If you are looking to convert any standard E27 screw socket into a motion detector lamp you can easily with the E27 PIR sensor adapter that can be set to activate whenever motion is detected, great for garages, stairwells, security installations or places your too lazy to manually switch on.
How to setup
All you need to begin is a E27 light socket and a bulb up to 60W
- Make sure the switch is turned off and no power is going to the socket;
- Unscrew the bulb from the screw socket;
- Screw the top of the PIR sensor adapter into the screw socket;
- Screw he bulb into the bottom of the screw socket;
- Adjust the sensitivity, light and timing screw to suit your installation;
- Turn on the light switch and leave it on;
- Setup is complete.
The light switch should be left on and the lighting will be controlled by motion detection and is based on the 3 adjustable screw settings.
PIR sensor range
The PIR sensor covers a full 360 degrees and can detect motion up to 6 meters , the diagram above shows the basic coverage of this sensor. Any movement within this area will trigger the light to turn on.
Basic Specs
- Socket: E27
- Working voltage: AC 110V OR 220V, 50/60Hz
- Max load: 60W (incandescent lamp) / 20W (energy saving lamp)
- Sensor spread: 360 degrees
- Sensor Type: IR Infared
- Suitable installation height: 2.8-3.5m
- Detection range: around 5m
- Timer Screw: Adjustable lighting time from 20s to 120s
- Light Screw : Adjust ambient brightness, adjust how dark the room needs to be before the sensor turns on.
- Sensor Screw: Adjust the sensitivity of the sensor to tune how easily the light is triggered on.
The E27 PIR sensor lamp easily converts any screw bulb socket into a fully operational sensor light simply and without the need of an electrician or custom installation, combine it with some energy saving lights and you have one optimized lighting solution. Grab one and never turn a light switch again.
English 
Français 
Español 
Deutsch